Bathroom Cleaner Formulations

Bathroom Cleaner Formulations

Bathroom Cleaner Formulations

Bathroom cleaners are produced in a range of formulations depending on the use, bath and tile cleaners, mould stain removers, limescale/rust removers, alkaline general purpose cleaners, these products are commonly formulated as ready to use sprays. The following formulations give superior performance in these applications:

Bath and Tile Cleaner

Amine oxide 5
Citric Acid 4
Water to 100

Charge the water followed by the citric acid, when fully dissolved charge the Amine oxide then mix until homogeneous. Spray the product onto soiled surfaces and allow to stand for 1-2 minutes, wipe off with a damp cloth or sponge before rinsing with water.

Mould Stain Remover

Amine oxide 5
Sodium hydroxide (50%) 1
sodium metasilicate pentahydrate 0.5
Sodium hypochlorite 14
Water to 100

Charge the water followed by the sodium hydroxide solution and sodium metasilicate, when fully dissolved charge the Amine oxide followed by the sodium hypochlorite solution then mix until homogeneous. Spray the product onto the mould stained area and allow to stand for 2-3 minutes, wipe off with a damp cloth or sponge before rinsing with water.

Lime/Rust Stain Remover

Amine oxide 10
Phosphoric acid 85% 12
Water to 100

Charge the water followed by the Amine oxide, then charge the phosphoric acid, mix until homogeneous. Whilst wearing gloves wipe the affected area with the product and rinse thoroughly with water, you can treat any heavier build-ups with the neat product. This product should not be used on marble, stone, terrazzo, metal or painted surfaces.

Alkaline Bathroom Cleaner

Alcohol ethoxylate (EO-L9) 0.5
Amine oxide 9
Sodium carbonate 2
Propylene Glycol n-Butyl Ether 1
Sodium Citrate to PH 10-11
Fragrance preservative dye as required
Water to 100

Charge the water and dissolve the sodium carbonate, then charge the Amine oxide and propylene glycol n-butyl ether, with good agitation dissolve the Alcohol ethoxylate. When homogeneous add fragrance and preservative as you require. To use the spray on soiled surfaces, allow to stand for 1-2 minutes before wiping off with a damp cloth or sponge before rinsing with water.

Featured Products: Alcohol ethoxylate (EO-L9), Amine oxide

IROTECH

ATTENTION: All information and data provided here are to the best of our knowledge and are intended for use by technical personnel at their own discretion and risk. We do not accept any liability or responsibility for any consequences arising from the use of this product for specific applications or commercial purposes. The user of the products is solely responsible for compliance with all laws and regulations applying to the use of the products, including intellectual property rights of third parties..